112
/140
D25M Camera Manual: Operating the Camera
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
3.2.5 Starting The Camera With The Factory IP Address
If your network has a DHCP server, you can start the MOBOTIX camera with DHCP support.
The camera automatically obtains an IP address from the DHCP server and announces the
new network data. Please note that this announcement can only be heard if the camera
is connected to an external speaker.
1. If the camera is powered on, disconnect the power supply by unplugging the cor-
responding cables and then reconnect the power supply.
2. Wait until both LEDs light up simultaneously for the first time.
3.
Press the R key within the next four seconds and hold it down
(if you need to
try again, go back to Step 1). Use a suitable device to press a key (a ball-point pen,
for example).
4.
After about 30 to 45 seconds
, the camera emits a double sound
(”boing boing”)
.
The camera has finished booting and can now be used (e.g., MxEasy, MxControlCenter,
MOBOTIX App, web browser).
Notes
Starting the camera with an automatic IP address (DHCP) is only
temporary
. The
network configuration of the camera can be permanently set to DHCP under
Admin
Menu > Ethernet Interface
.
Make sure that the network has a functioning DHCP server when starting the camera
with DHCP support. If this is not the case, the camera cannot obtain a valid IP address
and will use its last IP address.
You should also make sure that the cameras always obtain the same IP addresses by
permanently assigning the MAC addresses of the cameras to the desired IP addresses.
Passwords and cam-
era settings will
not be changed
Press the “R” key
In case of an error,
the camera uses its
last IP address
