Mobilogix ATD600S, User Manual

Page: 8 / 33

8
3 Function
3.1 Brief introduction of beacon scanning
3.1.1 When to scan beacons
There are two ways to scan beacons.
1. periodically sample (default 4h, GNSS sample frequency )
2. double press button
3.1.2 Beacon scanning
When the sampling period is reached, device begins to scan beacons for 10s (default, Duration of sleep beacon
scan ), then stop scanning until next calling. Enable/Disable/Scan Duration/Scan Period are configurable.
Notice:
1. Beacon scanning is disabled by default.
2. Beacon scanning can be configured by GNSS sample frequency, Duration of sleep beacon scan ). Sample
frequent should be more than 4 and report period should be less than or equal to 24h.
3. Data format:
{"000383":[{"ts":1615515383072,"values":{"mac":"5C:85:7E:20:01:F7","type":"250e","rssi":-
38,"bat":2915,"t":22.4,"h":60.6,"p":1010.0,"mj":1001,"mn":383,"gps":0,"lat":0.000000,"long":0.000000,"mcc":"
460","mnc":"00","lac":"1D2B","cellid":"2C5EB3F","gateway":"A600S20500002H"}}]}
3.2 Brief introduction of sampling location data
3.2.1 When to sample location data
There are four ways to get location data.
1. periodically sample (default 4h, GNSS sample frequency ).
2. UAM event trigged.
3. Low battery event trigged.
4. double press button
3.2.2 Get location data
On the upon conditions, device begins to sample location data once.
Notice:
1. Get location data is enabled by default.
2. Get location data can be configured by GNSS sample frequency . Sample frequent should be more than 4 and
report period should be less than or equal to 24h.
3. Data format: