10
CMCC","LAC":"25F0","CI":"DDF","GFT":0,"LAT":0.000000,"LONG":0.000000,"Heading":0,"Altitude":0.000000,"H
DOP":0.000000,"NoS":0,"GFS":0}}
3.4.3
Geofence in and/or out alarm
This alarm can be divided into
“
Geofence In
”
and
“
Geofence Out
”
alarm, after setting center point
) and radius of geofence cycle and enable it, device will report the alarm after get location
data from GPS. Here is an example of Geofence Out.
Notice:
1.
Geofence in and/or out alarm can be configured by
geofenceAlarm Point, geofenceAlarm Radius
2.
Geofence in and/or out alarm alarm is disabled by default.
3.
Data format:
{"ts":1615282576160,"values":{"ET":"GO","SN":"M420S202000086H","IMEI":"865284046405738","IMSI":"4600
46260108484","IPW":4115,"SS":0,"CS":"GSM","OP":"CHINA MOBILE
CMCC","LAC":"25F0","CI":"DDF","GFT":1615282575,"LAT":22.575430,"LONG":114.053322,"Heading":208,"Altitu
de":321.000000,"HDOP":11.400000,"NoS":4,"GFS":1}}
3.5
Power management
3.5.1
Into sleep
When BLE is not connected, on the one of the below circumstances, device will go to sleep, otherwise, device
will never fall asleep.
1.
sleep time is timeout (timeout value is different in different scenes, when sampling beacons, the value is
60S, when reporting messages, the value is 540S).
2.
If GPS is fixed, and there is no message need to be uploaded to the cloud, device will go to sleep in seconds.
3.
If GPS is not fixed, and there is no message need to be uploaded to the cloud, device will read GPS for about
30s then enter sleep.
3.5.2
Wake up
Wake up condition:
1.
UAM
2.
Button press
3.
periodically wake up (default 4h,
3.6
button and LED indication
3.6.1
Device under
“
normal work
”
mode
key action
function
Summary of Contents for ATD600S
