Rear View Mirror with Built-in Monitor
Model: M37
OPERATION AND INSTALLATION MANUAL
Congratulation on your purchase of a quality Mobilevision Rear
Observation System. This system has been designed to provide
the consumer with a product that is technologically superior
and will provide years of trouble free operation.
This product must be installed and used in accordance with
this manual. Any alteration or modification to the product,
the design or improper installation of this product is strictly
prohibited. Magnadyne Corporation assumes no responsibility
whatsoever for any injury or accidental death resulting from
the failure to properly install and operate this equipment.
Magnadyne also disclaims any and all liability that may result
from failure to install and operate in any other manner in which
this was intended.
Introduction
Caution!
The product is intended to assist in safe driving and allows the
driver to have a broader field of vision during backup. You, as
the driver, are solely responsible for the safe operation of your
vehicle and the safety of your passengers and pedestrians, and
for abiding of all state and local traffic regulations. Do not use
any features of this system to the extent it distracts you from
safe driving. Your first priority while driving should always be
the safe operation of your vehicle. Magnadyne will not accept
any responsibility whatsoever for accidents and/or injuries
resulting from failure to observe these precautions or safety
instructions.
General Operation
The mirror/monitor automatically activates every time the
ignition key is turned “On”. The mirror/monitor will turn Off
when the ignition is turned to the “Off” position.
Rearview Camera:
• When a rearview camera has been installed, whenever
the vehicle is shifted into reverse gear the monitor
will automatically display the camera image. The rear
observation camera image turns off automatically anytime
the gear selector is moved out of the reverse position.
• Pressing the CAM button will display the image from a 2nd
camera, such as an interior camera or front camera. Press
the CAM button again and the image from the 2nd camera
will no longer be displayed.
Note: If the vehicle is put into reverse the rearview camera
image will automatically be displayed on the monitor.
Installation Instructions
Mounting the Mirror/Monitor:
M37
1
M37 Mirror Mount
Mounting
Bracket
Screw
Mounting
Bracket
1. Remove the M37’s mirror mount by loosening the
mounting bracket screw.
2. Remove the factory mirror (do not use excessive force).
Check to make sure that the factory’s mirror mount
matches the M37’s mounting bracket. If the factory’s
mounting bracket does not fit the M37’s mounting bracket,
replace the factory’s mirror mount with the M37’s mirror
mount plate. Use medium Super Glue (not supplied) to
secure the mounting shoe to the windshield.
3. Slide the mounting bracket onto the mirror mount.
Move the bracket back and forth until the M37 is
completely seated.
4. Tighten the screw in the mounting bracket.
