EN
Mobicool DC/AC
Cleaning and maintenance
11
I
Connecting the cooler to 230 V (compressor mode)
➤
Connect the 230 V connection cable (fig.
3, page 2) to the 230 V AC
mains supply.
➤
Open the lid of the thermostat (fig.
3, page 2) by pressing down on it.
I
➤
Turn the thermostat (fig.
3, page 2) clockwise to the required position.
I
✔
The cooler starts cooling the interior.
➤
To switch off the cooler:
– Turn the thermostat (fig.
3, page 2) anti-clockwise to “0”.
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
7.3
Connecting to vehicle power
I
8
Cleaning and maintenance
A
NOTE
Disconnect the cooler from the battery when the engine is not run-
ning, as otherwise the battery will run down.
NOTE
Press down on the lid again to close it.
NOTE
The further you turn the thermostat towards “MAX”, the lower the
refrigerating temperature.
NOTE
If you connect the cooling device to the vehicle power, remember
that you may have to turn on the ignition to supply it with power.
NOTICE! Damage hazard
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
MobicoolMB40_OPM_4445103174_EMEA16_2020-xx-xx.book Seite 11 Donnerstag, 19. November 2020 5:18 17
