© MOBATIME
30 / 108
801104.05
6.5.6
MOBALine
MOBALine clock line with switch function for clock illumination, switch program and
world time function. Display of line 1 or 2
DTS 4132.timeserver Moser-Baer AG
====================================
MOBALine 1
1 Line type MBL
2 Line on
3 Linemode (min) min
4 Linemode (sec) jump
5 Time zone [+1] Brussel
6 Max. current 500mA
7 Switching function off
8 World time function off
9 Configure time zone table (world time)
98 Return and save
99 Return and discard changes
Enter desired menu number>
Path: 2 Configuration
1 Outputs
6/7 MOBALine / impulse line 1/2
1. Select line type: 0 = MOBALine, 1 = Impulse line, 2 = DCF active code line
2. Select line function: Line switched off, line switched on, let clocks run to 12:00.
3. Select MOBALine mode (minute hand): Minute steps, 30 second steps or cont. (10
sec. steps)
4. Select MOBALine mode (second hand): Jump, continuous with stop, continuous,
wobbling with stop
5. Select time zone (see chapter “6.5.28 Time zone selection“)
6. Select maximum current (0-700mA) on the line. The line will be switched off for as
long as the overcurrent is connected.
The maximum current is divided between both lines, i.e. it can always only be the
remainder at the most that can be set as the maximum amount.
7. Switch function on or off
8. World time function on or off
9. Configure time zone table for world time
Important:
Changes can only be undertaken when the clock line is switched off!
