MOBA MOBA-Matic MMC-1000, User Manual

Page: 95 / 172

Operation
95
Working with the slope sensor
8.3.1 Description
The slope sensor operates with a highly precise, electro -
mechanical measuring unit and is used for the acquisition of the
slope for the tool.
Sensor identification:
When the system is switched on, or with a sensor change, the
illustration in the controller display alternates (changes) between
the abbreviation for the Digi-Slope sensor and the side detection
(right = engl.: right or left = engl.: left).
=
8.3.2 Information for assembly
The slope sensor must be assembled on a machine part which
implements all slope amendments for the tool in the same
dimension.
In the case of a road milling machine, this is preferred in the
lower area of the machine (e.g. on the milling drum housing); on
the transverse traverse between the tow arms for blacktop
pavers.
Four fixing holes are provided on the fastening plate of the
sensor for the assembly works (refer to Section 11
“Technical
data
” for the housing drawing).
The plug connections must be freely accessible to ensure that the
connection of the connecting cable is easily possible. Please also
note the direction of installation (FWD/arrow pointing in the
direction of travel).