System Two LED Installation and Service Manual (1003385 Rev. C)
Page 55
Section 5
Installation and Removal for the HD Camera Assembly (Camera Lights only)
To install the HD Camera Assembly it is first necessary to remove the Sterilizable Handle Assembly as listed
above. Once the Sterilizable Handle Assembly has been
removed and the light head has the LED’s facing vertically
towards the ceiling, remove the outer housing on the camera by pushing the retaining ball and sliding the outer
housing off of the Camera Assembly. Then position the Camera Assembly so that the alignment pins align with the
corresponding alignment holes in the light head. Using one hand to prevent the light head from moving gently push
the Camera Assembly until it is firmly inserted into the light head. Then fasten the three captive screws and reinstall
the camera outer housing (a click will be heard when the housing is locked in place). The light head now has HD
Camera ready.
NOTE: The camera is a delicate instrument and must be handled with caution.
Figure 33: Camera Assembly (D2C only)
Figure 34: Inserting Camera Assembly (D2C only)