System Two LED Installation and Service Manual (1003385 Rev. C)
Page 39
Section 4
Positioning the Light
Figure 15: Positioning the Arms
Positioning the Arm System
The Figure illustrates the configuration example of
the System Two LED central axis S1.
The Extension Arm [4], Spring Arm [5] and the Light
Head or Monitor can be positioned easily. The swivel
range and the vertical lift can be restricted through
internal end stops.
Arms with standard Light Heads have continuous
rotation
Arms with Monitor Cradles or with Light Heads with
In-Light Cameras have rotational stops to prevent
the wires from being damaged during use.
Swiveling the Arm System
*** Notice ***
To prevent damage to the Arm System;
Do not hit the end stops hard
Avoid collisions with other components.
Slowly swivel the Light Head
Depending on the individual version the swivel
range ends at the internal end stops of the
Extension Arm [4] and the Spring Arm [5].
Adjusting the Height of the Arm System
*** Notice ***
If the Light Head or Monitor is moved upwards, there is
a risk that it could collide with other components.
Prior to adjusting the height, check for potential risks
of collision.
Slowly adjust the height of the Light Head.
The height adjustment is restricted by the internal
end stops of the Spring Arm [5]. If the Extension
Arm [4], the Spring Arm [5], the Light Head do not
remain stable in the set position, the spring tension
or brake force must be adjusted.