MKS Granville-Phillips 358 series, Instruction Manual

Page: 60 / 122

Chapter 4
60
Series 358 Micro-Ion Controller Instruction Manual - 358013 - Rev. B
4.13 Connecting a Capacitance
Manometer
If you have a Capacitance Manometer capability installed, signal voltages
are provided on the back of the Convectron Gauge module via a standard
1/8 in. miniature phone jack - the Analog Output B port shown in
Figure 4-4. Two mating connectors are supplied with this capability.
The wires provided for the capacitance manometer are terminaed as bare
wires. Refer to the documentation provided with the capacitance
manometer for connection instructions. Be sure to protect all unused leads
from shorting.
Figure 4-5Capacitance Manometer PCB
Figure 4-6 Capacitance Manometer Wiring Diagram