MK Martin Meteor 120, Operator'S Manual

Page: 12 / 44

12
120 Meteor® Snowblower
This Blower is ideal for tractors 150 - 200 HP Cat #2 3PH.
Attaching the Meteor® Blower for the first time.
Set the blower on a level surface and back the tractor up to it. Place the lower 3PH arms of the
tractor between the lower hitch plates on the blower and insert the hitch pins that came with
the blower, secure these with the Lynch Pins. Next swing the top link into place and adjust the
length so the top link pin can be inserted. You will have to supply the top link pin. With the top
link set at this length the blower will be flat or parallel to the ground.
Do not fasten the PTO shaft to the tractor.
1. Slowly lift the blower until the gearbox shaft is at the same height as the PTO output on
the tractor.
2. Push (or collapse the telescopic part of the PTO completely). If you cannot collapse it
far enough to slide get it on the tractor then it has to be shortened.
3. Measure the amount that the shaft is too long. Remove it from the blower and pull it
apart.
4. Take a hacksaw and cut the full length from each PTO half,
cut both the plastic tube
and the metal core.
5. Use a file to remove the burrs from the cut parts, wipe any filings from the surfaces and
slide the shaft together to be sure that it slides freely.
6. Make sure the plastic shield is free to rotate on the shaft before installing on the
machine.
7. Reinstall the PTO on the blower and fasten it to the tractor pushing the spring-loaded
pin in and sliding the yoke onto the tractor spline until the pin snaps into place.
8. Next lift the 3PH arms to the highest point, determine the overlap on the PTO shaft. It
should be at least 3” if it is too short then the PTO will jam rather then collapse. This will
put severe strain on the shaft and gearbox
.
9. It may come apart and this will allow a spinning PTO to become an uncontrolled
weapon and could severely injure or kill someone!
10. After it has been determined that the PTO is OK and will not jam or come apart, make
sure any bystanders are well away from the machine.
11. Lower the blower to ground level, engage the PTO and slowly start the blower. Make
sure that everything is turning freely.
12. Slowly increase the speed until you have reached 540 RPM on the PTO or (1000 RPM
with the 1000 RPM PTO option). This is the speed that this blower was designed for. If it
turns faster the fan could be going dangerously fast. If it turns slower it will not perform
very well as the snow will not get blown very far.
Snowblower performance will vary greatly due to ambient temperature and type of
snow
.