The USB Charger is suitable for charging portable electronic
devices connected via a USB 2.0 type A plug.
The USB Charger is suitable for use with all ranges of MK Euro
frontplates with at least a 2 module (50x50mm) aperture.
Rated mains supply voltage..........................220 to 240V a.c.
Mains frequency.........................................................50/60Hz
Rated input current.........................................................60mA
Power consumption (in standby)........................................0W
Output Voltage...............................................................5Vd.c.
Output Current..........................................................2.0A max
Total output Power............................................................10W
Charging Sockets............................................USB 2.0 type A
Operating temperature..........................................0°C to 40°C
Storage temperature..........................................-20°C to 70°C
Twin Charging Sockets: The USB Charger comes with two
charging sockets capable of delivering a total maximum charging
current of 2A. This can be delivered to either socket or divided
between the two as required and controlled by the devices being
charged.
Zero Standby: The USB Charger will draw no current from the
mains until a connector is inserted into either connection port.
Safety Isolation: The output of this product is fully isolated at
SELV level to provide maximum protection for your safety.
Output Overload Protection: The USB Charger is protected
against over-current and short circuit conditions on the output.
3
2
A. INTRODUCTION
B. PRODUCT FEATURES
5
4
The USB Charger complies with the following EC directives:
Low Voltage Directive (73/23/EEC)
Electro-Magnetic Compatibility Directive (89/336/EEC)
They also comply with the requirements of the following
Standards:
IEC 61558-2-16
IEC 61000-6-1 and IEC 61000-6-3
D. STANDARDS & EC DIRECTIVES
USB Charger
Euro Module
K5837WHI, K5837BLK, K5837SGRY,
K5837SCW
Contents
A Introduction
2
B Product Features
2
C Specification
3
D Standards & EC Directives
4
E Safety
Instructions
5
F Installation
7
G Maintenance & Disposal
10
H Guarantee
11
Please leave this leaflet with the end user
for future reference
50078098.001_Rev.A
by Honeywell
E. SAFETY INSTRUCTIONS
6
®
C. SPECIFICATION
1. To prevent the risk of electrocution, turn off the mains
electricity supply before commencing work on the instal-
lation of this product.
2. To ensure safe installation:
- This product must be installed by a competent person
(e.g. a qualified electrician) in accordance with these
instructions and the appropriate current national wiring
regulations, (e.g. the IEE wiring regulations BS 7671).
- Where the mounting box incorporates an earth terminal,
it must be connected to the circuit protective (Earth) con-
ductor.
NOTE: All bare earth wires must be covered with appro-
priate green/yellow sleeving.
- It is essential that all connections are made as instructed,
that the cables are not stressed and that the terminal
screws are fully tightened.
3. This product MUST NOT be installed in bathrooms,
washrooms or any location subject to splashes of water,
condensation or excessively damp conditions.
4. Ensure that the product is mounted on an even surface in
the vertical plane.
5. Do not use the USB Charger in ambient temperatures
higher than the maximum specified operating temperature.
6. This product contains no user serviceable parts. DO NOT
attempt to open the module as this will invalidate your
warranty.
NOTE: The front surface of this product will naturally become warm
in use. This is normal and is not a cause for concern