Operating Instructions MG3 Digital
Operation
76609409EN-BA-MG3D-V1_6.docx 25/82
2010-08-02
4.1.2.1
Display Windows – Quadrant 1 to 4
Representation of the measured values in four, freely configurable display windows
(quadrants).
Any display window can be run in one of the following display modes:
•
numeric
•
graphical
•
SPC*-Chart
•
SPC*-Values
* SPC: Statistical Process Control
Selection of any quadrant by rotating the knob/pushbutton combination.
Depressing the knob/pushbutton combination offers a magnified and more detailed view
of the quadrant with additional setting possibilities. Depressing the main display field once
more goes back to the previous display.
Numeric display specific feature
After a measurement, the measured value of the numeric display can flash colored or
gray.
This means in this case:
•
yellow: the current set pre-warning value is not reached or exceeded
•
red: the current set limit value is not reached or exceeded
•
grey: measurement was invalid (range overflow)
4.1.2.2
Menu Bar
The menu bar comprises the:
•
Readout/setting of the current program number (1…99)
•
Display of the current measuring mode (SINGLE/CONT.)
•
Switches for selecting displays and measuring mode
4.1.2.3
Program Display
The program displays informs you about the number of the currently running measuring
program. The indicating range is 1 to 99.
Program selection through the knob/pushbutton combination.
4.1.2.4
Measuring Mode
Here you can read the measuring mode that the measuring instrument is running right
now.
You can select two measuring modes through the knob/pushbutton combination:
•
Single measurement (SINGLE) or
•
Continuous measurement (CONT.)
4.1.2.5
Status Bar
Depending on the control elements selected, the status bar shows you:
•
Information on the last measurement (channel 1/2)
•
Details on the meaning of the control elements selected
•
Information on the condition of the function selected
•
Fault messages
