A-3
[Wiring Precautions]
CAUTION
z
Be sure to ground the FG terminals to the protective ground conductor.
Not doing so could result in electric shock or erroneous operation.
z
Use applicable solderless terminals and tighten with the specified torque. If
any solderless spade terminal is used, it may be disconnected when the
terminal screw comes loose, resulting in failure.
z
When turning on the power supply or operating the module after installation
or wiring work, be sure that the module's terminal covers are correctly
attached.
Not attaching the terminal cover could result in electric shock.
z
Tighten the terminal screws with the specified torque.
If the terminal screws are loose, it could result in short circuits, fire, or
erroneous operation.
Tightening the terminal screws too far may cause damages to the screws
and/or the module, resulting in fallout, short circuits, or malfunction.
z
Be sure there are no foreign substances such as sawdust or wiring debris
inside the module.
Such debris could cause fires, damage, or erroneous operation.
z
The module has an ingress prevention label on its top to prevent foreign
matter, such as wire offcuts, from entering the module during wiring.
Do not peel this label during wiring.
Before starting system operation, be sure to peel this label because of heat
dissipation.
Summary of Contents for Q62DAN
Page 19: ...13 MEMO ...
