88
2410
• The specified program does not exist
in the program memory.
This error may occur when the
ECALL, EFCALL, PSTOP, PSCAN,
POFF or PLOW instruction is
executed.
• The specified file does not exist.
• Read the individual information of the
error using the peripheral device,
check to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Create a file created using
parameters, and load it to the CPU
module.
• In case a specified file does not exist,
write the file to a target memory and/
or check the file specified with the
instruction again.
QnA
2411
• The file is the one which cannot be
specified by the sequence program
(such as comment file).
• The specified program exists in the
program memory, but has not been
registered in the program setting of
the Parameter dialog box.
This error may occur when the
ECALL, EFCALL, PSTOP, PSCAN or
POFF instruction is executed.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
QnA
2412
The SFC program file is one that cannot
be designated by the sequence
program.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
QnA
2413
No data has been written to the file
designated by the sequence program.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Check to ensure that the designated file
has not been write protected.
QnA
Error
Code
(SD0)
Error Contents and Cause
Corrective Action
Corresponding
CPU
