Mitsubishi Pajero Sport 2013, Inspection And Maintenance Manual

Page: 94 / 94

OTHERS
PERIODIC INSPECTION AND MAINTENANCE
2-66
2. Disconnect the harness connector.
3. Connect a hand vacuum pump to nipple (A) of the
solenoid valve (refer to the illustration at left).
4. Check air tightness by applying a vacuum with
voltage applied directly from the battery to the
EGR control solenoid valve and without applying
voltage.
5. Measure the resistance between the terminals of
the solenoid valve.
Standard value: 29
−
35
Ω
(at 20
°
C)
OTHERS
F1. CHECK BODY CONDITION FOR
DAMAGE
M6020700100384
1. Check underbody coating for damage.
2. Check body painting for damage.
F2. CHECK THE COMMON RAIL ENGINE
(small injection quantity learning)
M6020700400103
LEARNING PROCEDURE
1. After the ignition switch is in "LOCK" (OFF)
position, connect the M.U.T.-III to the diagnosis
connector.
2. Put the vehicle in the following idling stable
conditions:
•
Engine coolant temperature: 80
−
90
°
C
•
Automatic transmission fluid temperature: 60
°
C
or higher
•
Lamps, A/C condenser fan and all accessories:
OFF
•
Transmission: Neutral <M/T>, "P" range <A/T>
•
Power steering: Static state
3. Select SPECIAL FUNCTION from the function
menu.
4. Select SMALL INJECTION QUANTITY
LEARNING from the SPECIAL FUNCTION menu
to execute learning.
CAUTION
•
If the vehicle conditions go out of the learning
conditions during idling, learning is inter-
rupted.
•
To reexecute learning, the ignition switch
must once be turned off.
5. Continue idling for about 3 minutes before
learning is completed.
6. Confirm that the engine warning lamp is off. If it
still blinks, reexecute learning.
F3. ROAD TEST
M6020700200637
Drive the vehicle and check for conditions.
1. Check free play of steering wheel.
2. Check efficiency of service brakes and parking
brakes system.
3. Check driveability of engine.
4. Check condition of instruments, gauges
indicators, exterior lamps, heater and ventilators.
5. Check abnormal noise of each part.
6. Check the tyres for wear and for the correct air
pressure.
Battery
voltage B nipple
condition Normal
condition
Not applied Open Vacuum
maintained
Applied Open Vacuum leaks
Closed Vacuum
maintained
AK600249 AB
Diagnosis
connector
MB991827
MB991824
MB991910