PRECAUTIONS BEFORE SERVICE
GENERAL
0-4
BRAKE FLUID
M6001000900025
Be careful to avoid spilling any brake fluid, because if
it adheres to the vehicle body, the paint coat might be
discoloured.
SERVICING THE ELECTRICAL SYSTEM
M6001001000070
CAUTION
Before connecting or disconnecting the negative
(-) cable, be sure to turn off the ignition switch
and the lighting switch. (If this is not done, there
is the possibility of semiconductor parts being
damaged.)
Before replacing a component related to the electri-
cal system and before undertaking any repair proce-
dures involving the electrical system, be sure to first
disconnect the negative (-) cable from the battery in
order to avoid damage caused by short-circuiting.
APPLICATION OF ANTI-CORROSION
AGENTS AND UNDERCOATS
M6001001100022
If oil or grease gets onto the oxygen sensor, it will
cause a drop in the performance of the sensor.
Cover the oxygen sensor with a protective cover
when applying anti-corrosion agents and undercoats.
PRE-INSPECTION CONDITION
M6001001200115
"Pre-inspection condition" refers to the condition that
the vehicle must be in before proper engine inspec-
tion can be carried out. If you see the words "Set the
vehicle to the pre-inspection condition". In this man-
ual, it means to set the vehicle to the following condi-
tion.
•
Engine coolant temperature: 80 to 90
°
C
•
Lamps, electric cooling fan and all accessories:
OFF
•
M/T: Neutral
•
A/T, CVT: P range
VEHICLE WASHING
M6001001300112
If high-pressure car-washing equipment or steam
car-washing equipment is used to wash the vehicle,
be sure to note the following information in order to
avoid damage to plastic components, etc.
•
Spray nozzle distance: Approximately 40 cm or
more
•
Spray pressure: 3,900 kPa or less
•
Spray temperature: 82
°
C or less
•
Time of concentrated spray to one point: within
30 sec.
AC305285
ACX00880AD
AC300832AC
Approximately
40 cm or more
Summary of Contents for Pajero Sport 2013
Page 6: ...NOTES...
Page 16: ...BODY PRE DELIVERY INSPECTION 1 10...