Mitsubishi NZ2GFCF-D62PD2, User Manual

Page: 282 / 304

280
(20)Station-based control data (address: 1005
H
)
(21)Extended parameter data (address: 1500
H
to 1521
H
)
Address Name Description Default
1005
H
Module operation
information
initialization
completed
• When initialization of the module operation information stored in the remote
buffer memory and the nonvolatile memory is completed, Module operation
information initialization completed (address: 1005
H
) changes to Initialization
is completed (1).
• When Module operation information initialization command (address: 1004
H
)
is set to Not commanded (0), Module operation information initialization
completed (address: 1005
H
) changes to Initialization is not performed (0).
• The following shows the range of values which can be stored.
0000
H
Address Name Description Default
1500
H
Cam switch function,
step type (Output 1)
Set the step type for the cam of Output 1.
• Setting range
0: Starts with output status being OFF
1: Starts with output status being ON
• The reflection timing of the setting value
When CH  Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
0
1501
H
Cam switch function,
number of steps
(Output 1)
Set the number of steps for the cam of Output 1.
• Setting range
0 to 16
• The reflection timing of the setting value
When CH  Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
0
1502
H
1503
H
Cam switch function,
step No.1 setting
(Output 1)
Set the count value for switching ON and OFF of the output at the step No.1 of
Output 1.
• Setting range
-2147483648 to 2147483647
• The reflection timing of the setting value
When CH  Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
0
... ... ... ...
1520
H
1521
H
Cam switch function,
step No.16 setting
(Output 1)
Set the count value for switching ON and OFF of the output at the step No.16 of
Output 1.
• Setting range
-2147483648to 2147483647
• The reflection timing of the setting value
When CH  Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 (fixed)
b15 b0 b1 b2 b3 b4 b5 b6 b7 b8 b9 b10 b11 b12 b13 b14
0: Initialization is
not performed
1: Initialization is
completed