Mitsubishi NZ2GFCF-D62PD2, User Manual

Page: 259 / 304

257
APPENDICES
A
Appendix 2 Details of R
emote Registers
(3) Remote registers (RWr10 to RWr17, RWr28 to RWr2F)
*1 For Δ T
2
, refer to Page 283, Appendix 4.
Address
(RWr)
Item Description Default
CH1 CH2
10
11 28
29
Present value
• This area stores the counter present value.
• The update cycle of this area is Δ T
2
.
*1
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
0
12
13 2A
2B
Latch count value
• This area stores the count value latched when the latch counter function
(counter function selection) or the latch counter/preset/replace function is
selected. (For the overview of the operation, refer to Page 133, Section 8.8 or
Page 145, Section 8.12.)
• This area stores the value which is stored in CH

Present value (RWr10 to
RWr11, RWr28 to RWr29) of when CH

Function input terminal (FUNC1,
FUNC2) or CH

Selected counter function start command (RY25, RY3D) is
input.
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
0
Sampling count value
• This area stores the count values in the sampling period when the sampling
counter function is selected. (For the overview of the operation, refer to Page
136, Section 8.9.)
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
Periodic pulse count,
difference value
• This area stores the count value per cycle time (the difference value) when the
periodic pulse counter function is selected. (For the overview of the operation,
refer to Page 139, Section 8.10.)
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
14
15 2C
2D Periodic pulse count,
present value
• This area stores the value which is stored in CH  Present value (RWr10 to
RWr11, RWr28 to RWr29) after the cycle time elapsed when the periodic pulse
counter function is selected.
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
0
16
17 2E
2F Periodic pulse count
value update check
• This area stores the same value as the value in CH

Periodic pulse count,
difference value (RWr12 to RWr13, RWr2A to RWr2B) when the periodic pulse
counter function is selected.
• When CH

Periodic pulse count, difference value (RWr12 to RWr13, RWr2A
to RWr2B) is not equivalent to CH

Periodic pulse count value update check
(RWr16 to RWr17, RWr2E to RWr2F), a data mismatch occurs. Read again
CH

Periodic pulse count, difference value (RWr12 to RWr13, RWr2A to
RWr2B), CH

Periodic pulse count, present value (RWr14 to RWr15, RWr2C
to RWr2D), and CH

Periodic pulse count value update check (RWr16 to
RWr17, RWr2E to RWr2F).
• When Initial data setting request flag (RY9) is turned off then on, the value in
this area is cleared.
0