Mitsubishi NZ2GF2B-60DA4, User Manual

Page: 72 / 174

70
7.2.2
Changing the parameter without changing the network
configuration
To change only the created module parameter of the slave station without changing the network configuration, set the
parameter in the following procedure.
1.
Display the "CC IE Field Configuration" window.
• When the master/local module is the QJ71GF11-T2
Project window [Parameter] [Network Parameter]
[Ethernet/CC IE/MELSECNET] button
• When the master/local module is the LJ71GF11-T2
Project window [Parameter] [Network Parameter] [CC IE Field]
button
2.
Select the D/A converter module in "List of stations" on the "CC IE Field Configuration" window.
3.
Open the "Parameter Processing of Slave Station" window.
[CC IE Field Configuration] [Parameter Processing of Slave Station]
4.
Set "Parameter read" for "Method selection".
5.
Click the button to read the parameter from the D/A converter module.
List of stations