Mitsubishi -NAFR-F720-00167-NA, Instruction Manual, Page: 336 / 413

326
Parameter copy and parameter verification
4.27 Parameter copy and parameter verification
4.27.1 Parameter copy
PCPY Setting Description
0 Cancel
1 Copy the source parameters to the operation panel.
2 Write the parameters copied to the operation panel into the destination inverter.
3 Verify parameters in the inverter and operation panel. (Refer to page 327.)
REMARKS
· When the copy destination inverter is not the FR-F700 series or parameter copy write is performed after parameter copy read is
stopped, "model error ( )" is displayed.
· Refer to the parameter list on page 390 and later for availability of parameter copy.
· When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy write, perform write again or check the
values by parameter verification.
· Initial settings of certain parameters are different for different capacities, so some parameter settings may be automatically
changed when parameter copy is performed from a different-capacity inverter. After performing a parameter copy from a
different-capacity inverter, check the parameter settings. (Refer to the parameter list
(page 62 )
for the parameters with different
initial settings for different capacities.)
· If parameters are copied to the inverter with additional parameters (version up model) from the inverter without additional
parameters, a value out of the setting range may be written to the inverter. In this case the inverter operates as if the initial value
is written to the parameter.
Parameter settings can be copied to multiple inverters.
1.
Connect the operation panel to the
copy source inverter.
•
Connect it during a stop.
Display Operation
2.
Press to choose the parameter
setting mode.
Flicker ··· Parameter copy complete!!
6.
Press to copy the source parameters
to the operation panel.
4.
Press to to read the present set value.
" "(initial value) appears.
Flicker ··· Parameter copy complete!!
9.
Press to write the parameters copied to
the operation panel to the destination inverter.
3.
Turn until (parameter copy)
appears.
5.
Turn to change it to
the setting value " ".
The frequency flickers
for about 30s
The frequency flickers
for about 30s
About 30s later
10.
When copy is completed,
" " and " " flicker.
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power OFF once, before starting operation.
7.
Connect the operation panel to the
copy destination inverter.
8.
After performing steps 2 to 5,
turn to change it to " ".
The parameter
number previously
read appears.