Mitsubishi MZ360360EX, Installation Instructions Manual

Page: 39 / 51

- 39 -
3) Within 10 seconds after the sound of the buzzer in the above step 2), push
three switches (Function Switch, Start Switch, and Stop Switch) on the right side
of the remote controller at the same time for 1 second or more.
The buzzer of the remote controller sounds when pushing for 1 second or more,
and the Start Mark and Stop Mark begin blinking.
OK
Faulty remote
controller
NG
Beep
Pushes at the same time
for 1 second or more
While the Start Mark and Stop Mark of the remote controller is blinking (about 20
seconds), perform the following operations 4) and 5).
4) Insert the ignition key into the key cylinder and turn the key from LOCK (OFF) to ACC
to LOCK (OFF).
When the key is returned to the LOCK(OFF) position, the buzzer of the ECU will beep
once. Then remove the ignition key.
5) Perform the engine stop operation by the remote controller.
If the remote controller is operated correctly, the buzzer of the ECU will beep twice.
NG
If any switch except the engine stop switch is pushed in the above step 5), the registration operation is
discontinued.
(The Start Mark and Stop Mark stop blinking, and all the marks on display are turned off.)
If the registration operation is discontinued by misoperation, disconnect the (-) terminal of the vehicle's
battery once and reconnect it, and then retry the registration procedure from the beginning.
Note
Registration is completed
OK
Beep
Pushes the Stop Switch
for 1 second or more
Faulty remote
controller, ECU
or antenna