68
5 INSTALLATION
5.3 Procedures for Installing on and Detaching from DIN Rail
Installation of extension modules (extension cable type)
Installation of terminal modules
Removal of CPU module
1.
Push out the DIN rail mounting hook (A in the right figure) of the
extension module (extension cable type).
2.
Fit the upper edge of the DIN rail mounting groove (B in the right
figure) onto the DIN rail.
3.
Push the product against the DIN rail.
4.
Lock the DIN rail mounting hooks while pressing the product
against the DIN rail.
5.
Connect the extension cable. For the connecting procedure of the extension cables, refer to
Methods for CPU Module and Extension Devices.
1.
Turn off all the power supplies connected to the CPU module,
extension modules, or terminal modules.
2.
Fit the upper edge of the DIN rail mounting groove (A in the right
figure) onto the DIN rail.
3.
Push the product against the DIN rail.
1.
Remove the connection cables including power cables and I/O
cables.
2.
Insert the tip of a flathead screwdriver into the hole of the DIN rail
mounting hook (B in the right figure). This step also applies for
the DIN rail mounting hooks of the expansion adapters or
extension modules (connector type).
3.
Move the flathead screwdriver as shown in the right figure to
draw out the DIN rail mounting hooks of all devices.
4.
Remove the product from the DIN rail (C in the right figure).
5.
Push in the DIN rail mounting hooks (D in the right figure).
Back side
A
1
B
3
3
A
C
B
3
4
2
5
D
Summary of Contents for MELSEC iQ-F FX5UC
Page 1: ...MELSEC iQ F FX5UC User s Manual Hardware ...
Page 2: ......
Page 15: ...13 CONTENTS ...
Page 183: ......
