Mitsubishi MELSEC-F FX2N-1RM-E-SET, User Manual

Page: 84 / 140

Program Operating Procedures 8
8-4
FX
2N
-1RM-E-SET Programmable Cam Switch
8.2.3 Write and modification
Read the step No. to be written or modified, then set the ON/OFF angle of the output.
When writing new data, perform the write operation in the order of "ON angle" and "OFF angle".
When modifying the existing data, the ON angle or the OFF angle can be modified separately.
• When setting the ON/OFF angle of an output or the angle advance quantity of the automatic
angle advance function from the data setting panel, use the [
⋅
] key to enter "0.5 degree".
Example: When setting "90.5 degree"
Press the [9], [0] and [
⋅
] keys. A decimal point is also displayed on the DEG display.
[Power ON] [PRG mode]
BANK 0 GO
OUT 0 GO
ON
OFF
1 2 3
ON
OFF
GO
or
1 3 5
GO
STEP 0 GO
Read the program bank
No. 0.
Read the output Y00.
Read the step No. 0.
Start to set ON/OFF of the
output Y00.
Enter the ON angle of the
output Y00.
Determine the ON angle.
When data is newly written
or the [ON OFF] key is
pressed, the process
proceeds to setting of the
OFF angle. When the
existing data is modified, the
contents of modification are
written to the EEPROM when
the [GO] key is pressed.
Enter the OFF angle of the
output Y00.
Determine the OFF angle.
The ON/OFF set angle of the
output Y00 entered is written
to the built-in EEPROM.
BANK
0
OUT
0
STEP
0
DEG
Blank*1
ON LED
Lit
OFF LED
Exting-
uished
< Key operation >
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
< Display >
*1 When a modification operation is
performed, the ON angle of the output
Y00 already registered is displayed.
On the DEG , "0" is displayed or an angle already
registered flashes.
The ON LED is lit to indicate that the ON angle
setting operation is being performed.
"123" flashes on the DEG.
The OFF LED is lit to indicate that the process
has proceeded to the OFF angle setting
operation of the same step.
"135" flashes on the DEG.
The data setting operation proceeds to the next step,
and the data setting panel becomes the following
status.
BANK
0
OUT
0
STEP
1
DEG
Blank*2
ON LED
Lit
OFF LED
Exting-
uished
*2 When a modification operation is
performed, the ON angle of the next step
already registered is displayed.
●
When the data entered is equivalent to (overlaps)
the existing ON/OFF angle, the error indication
"E02" is displayed. At this time, the data entered is
not written.
●
When the [GO] key is pressed at the end of the
OFF angle setting operation for the step No. 7, the
step 0 of the same bank is displayed.