Mitsubishi MELSEC-F FX2N-1RM-E-SET, User Manual

Page: 81 / 140

Program Operating Procedures 8
8-1
FX
2N
-1RM-E-SET Programmable Cam Switch
8. Program Operating Procedures
This section describes the program operating procedures in the FX
2N
-1RM using the data setting
panel.
8.1 Functions offered by the data setting panel
< Data setting panel function list >
In addition to the following list. There is a monitor mode (refer to 9.1) and a test mode (refer to
10.1)
Item Function Mode
Description
page
Read Reads a program. PRG 8-3
Write Writes and modifies a program. PRG 8-4
Insertion Inserts a program. PRG 8-5
Deletion Deletes a program. PRG 8-6
Bank copy Copies contents of existing bank to specified bank. PRG 8-8
Output copy
Copies contents of existing output to specified output of same
bank.
PRG 8-8
Teaching modification Treats current position of resolver as set value. PRG 8-9
Teaching insertion Inserts current position of resolver as set value. PRG 8-10
Forced RUN/PRG
Changes over mode between RUN (operation) and PRG (stop/
program) from data setting panel to FX
2N
-1RM.
PRG 8-11
Read of reference angle Reads and displays reference angle. PRG 8-12
Setting of reference angle Modifies reference angle. PRG 8-12
Specification of resolution Specifies resolution (0.5 degree or 1 degree). PRG 8-13
Specification of rotation
direction Specifies rotation direction of resolver (counterclockwise or
clockwise).
PRG 8-13
Write-protect of EEPROM
Specifies availability of write to EEPROM (prohibited or
enabled).
PRG 8-14
Setting of bank
specification method
Specifies bank specification method (external input or PLC). PRG 8-14
Setting of automatic angle
advance function Specifies use of automatic angle advance function, and sets
rotation speed and angle advance quantity.
PRG 8-15
Individual automatic angle
advance function The output number, rotational speed, and angle advance
quantity of individual automatic angle advance function is set.
PRG 8-17
Prohibition of RUN to
PRG operation
The RUN to PRG operation with data setting panel is prohibited. PRG 8-21
Current angle transfer
function Current angle of the resolver is transferred to BFM#106 via
turning ON input terminal B1.
PRG 8-21
Reverse of output pattern Reverses output pattern of existing program. PRG 8-22
Batch addition of output
set angle Adds specified angle to set angle of specified output pattern at
a time.
PRG 8-23
Batch subtraction of
output set angle Subtracts specified angle from set angle of specified output
pattern at a time.
PRG 8-23
Batch addition of ON
output set angle Adds specified angle to ON set angle of specified output at a
time.
PRG 8-24
Batch subtraction of ON
output set angle Subtracts specified angle from ON set angle of specified output
at a time.
PRG 8-24