Mitsubishi GX Configurator-AD, User Manual

Page: 64 / 208

3 - 41 3 - 41
MELSEC-Q
3 SPECIFICATIONS
3.4.10 Offset/gain setting mode (buffer memory addresses 22, 23: Un\G22, Un\G23)
(1) Specifies the channel to be adjusted for the offset/gain settings.
(2) The channel for which the offset is to be adjusted is specified in buffer memory
address 22 (Un\G22) and the channel for which the gain is to be adjusted is
specified in buffer memory address 23 (Un\G23).
(3) Although it is possible to set multiple channels at the same time, set the offset and
gain separately (buffer memory addresses 22, 23: Set either Un\G22 or Un\G23 to
0). If both are set at the same time, an offset/gain setting mode error (error code
500) occurs.
(4) See Section 4.6 for the details of the offset/gain settings.
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
CH4 CH3 CH2 CH1
CH4 CH3 CH2 CH1
0
0
0
0
0
0
0
0
Un\G22 (Offset specification)
Un\G23 (Gain specification)
For Q64AD-GH, information of b4 to b15 is fixed at 0.
For Q62AD-DGH, information of b2 to b15 is fixed at 0. 1 : Channel to be set
0 : Invalid
3.4.11 CH maximum value/minimum value storage area (16bit) (buffer memory addresses
30 to 37: Un\G30 to Un\G37)
(1) The value in the maximum value/minimum value storage area (32bit) (buffer
memory addresses 62 to 77: Un\G62 to Un\G77) is converted and the result of
conversion is stored in 16-bit signed binary.
(2) The stored values for all channels will be cleared to 0 when the operating
condition setting request (Y9) is set to ON and the setting is changed or when the
maximum value/minimum value reset request (YD) is set to ON.
(3) The maximum and minimum values are stored for each sample processing time
(measurement), even with channels for which averaging processing is specified.