Mitsubishi FX3U-32DP, User Manual

Page: 32 / 74

26
FX
3U
-32DP PROFIBUS-DP Interface Block
User’s Manual
3 Installation
3.2 Mounting
3.2.2 DIN Rail Mounting
The 32DP can be mounted on a DIN rail (DIN46227, 35mm width).
→
For detail, refer to FX
3G
PLC Hardware Edition
→
For detail, refer to FX
3GC
PLC Hardware Edition
→
For detail, refer to FX
3U
PLC Hardware Edition
→
For detail, refer to FX
3UC
PLC Hardware Edition
→
For detail, refer to MELSEC iQ-F FX5U User's Manual (Hardware)
→
For detail, refer to MELSEC iQ-F FX5UC User's Manual (Hardware)
Note
• An interval space between each unit of 1 to 2 mm (0.04" to 0.08") is necessary.
• When connecting the 32DP to an extension unit/block (or special function unit/block), first mount the
extension unit/block (or special function unit/block) to the right side of the PLC.
DIN Rail Mounting
1) Fit the upper edge of the DIN rail mounting groove (right fig. A) onto the DIN
rail.
2) Push the product onto the DIN rail.
3) Connect the 32DP’s extension cable (right fig. B) to the
extension device connector of the main unit.
→
For extension cable connection procedures of the FX
3G
Series PLC, refer to FX
3G
PLC Hardware Edition
→
For extension cable connection procedures of the FX
3GC
Series PLC, refer to FX
3GC
PLC Hardware Edition
→
For extension cable connection procedures of the FX
3U
Series PLC, refer to FX
3U
PLC Hardware Edition
→
For extension cable connection procedures of the FX
3UC
Series PLC, refer to FX
3UC
PLC Hardware Edition
→
For extension cable connection procedures of the FX5U PLC,
refer to MELSEC iQ-F FX5U User's Manual (Hardware)
→
For extension cable connection procedures of the FX5UC PLC,
refer to MELSEC iQ-F FX5UC User's Manual (Hardware)
Removing from DIN Rail
1) Disconnect the PROFIBUS-DP communication cable and extension cables.
2) Insert the tip of a flathead screwdriver into the hole of the DIN rail
mounting hook (right fig. A).
3) Move the flathead screwdriver as shown in the figure to the right, pull
out the DIN rail mounting hook (right fig. A).
4) Remove the product from the DIN rail (right fig. B).
2)
1)
A
B
A
2)
4)
3)