Mitsubishi FUSO FH 1997, Service Manual

Page: 106 / 200

01-9
01
Draining of Water Separator Condensation
Ê
Tightening torque
Unit : N·m {lbf.ft, kgf·m}
Location Parts to be tightened Tightening torque Remarks
2
Drain plug 2.9 to 3.9 {2.2 to 2.9, 0.3 to 0.4} —
Visually inspect the water separator before driving.
When float 1 reaches red line A, drain the condensation as follows:
• Loosen drain plug 2 and drain out the condensation.
• When float 1 has dropped to the bottom, tighten drain plug 2.
• Carefully wipe the water separator and the surrounding area.
• Check for fuel leakage.
Cleaning of Fuel Feed Pump Gauze Filter
Ê
Tightening torque
Unit : N·m {lbf.ft, kgf·m}
Location Parts to be tightened Tightening torque Remarks
2
Eye bolt 25 to 29 {18 to 22, 2.5 to 3} —
WARNING
–
• Fuel ignites easily. Do not get it near flame or heat.
• Wipe up any gas oil that has been spilled because it can cause a
fire.
• Remove eye bolt 2 on the inlet side of fuel feed pump 1.
• Remove gauze filter 3 from eye bolt 2.
• Clean gauze filter 3 with gas oil.
• Follow the removal sequence in reverse and reinstall gauze filter 3.
Install eye bolt 2 in the fuel feed pump.
• Bleed the air from the fuel line.
• Start the engine and check for fuel leakage.
02210
02209
2 3
1
A
1
2
A
1
2