Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 58 / 538

l Pressing the LOCK or UNLOCK switch
on the key.
(After pressing the LOCK switch, the
vehicle will lock if all the doors and the
tailgate are closed, after which the sys-
tem preparation mode will once again go
into effect.)
l Turning the ignition switch to the “ON”
position. (except for vehicles equipped
with the keyless operation system)
l Putting the operation mode in ON. (vehi-
cles equipped with the keyless operation
system)
l Holding the keyless operation key and
locking or unlocking the doors and the
tailgate using the keyless operation func-
tion (vehicles equipped with the keyless
operation system).
NOTE
l Even if a door or the tailgate is closed while
the inside alarm is activating, this will not
cancel the alarm activation. (except for vehi-
cles equipped with the interior alarm sensor)
Please check the inside of the vehicle to con-
firm that nothing was stolen.
NOTE
l
When the ignition switch is turned to the
“ON” position or the operation mode is put
in ON, the buzzer sounds four times. This
operation indicates that the alarm was acti-
vated while the vehicle was parked.
Please check the inside of the vehicle to con-
firm that nothing was stolen.
l Even if the battery is disconnected, the alarm
activation memory will not be erased.
Electric window control
E00302201775
The electric windows can only be operated
with the ignition switch in the “ON” position
or the operation mode in ON.
Electric window control switch
E00302303376
Each door window opens or closes while the
corresponding switch is operated.
Driver’s switches
(LHD) Driver’s switches
(RHD)
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window
4- Rear right door window
5- Lock switch
WARNING
l
Before operating the electric window con-
trol, make sure that nothing can get trap-
ped (head, hand, finger, etc.).
l Never leave the vehicle without removing
the key.
l Never leave a child (or other person who
might not be capable of safe operation of
the electric window control) in the vehicle
alone.
Driver’s switches
The driver’s switches can be used to operate
all door windows. A window can be opened
or closed by operating the corresponding
switch.
Press the switch down to open the window,
and pull up the switch to close it.
If the switch for the driver’s window is fully
pressed down/pulled up, the door window au-
tomatically opens/closes completely.
If you want to stop the window movement,
operate the switch lightly in the reverse direc-
tion.
Electric window control
3-30
OGKE18E1
Locking and unlocking
3