Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 282 / 538

l A wireless facility or device using the
same frequency is near the vehicle.
l Snow or ice is stuck inside the fenders
and/or on the wheels.
l
The tyre inflation pressure sensor’s bat-
tery is dead.
l Wheels other than MITSUBISHI
MOTORS GENUINE wheels are being
used.
l
Wheels that are not fitted with tyre infla-
tion pressure sensors are being used.
l Wheels whose ID codes are not memo-
rized by the vehicle are used.
l A window tint that affects the radio
wave signals is installed.
NOTE
l
Tyre inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tyre inflation pressures may be underinflated
(causing the warning lamp/display come on)
when the ambient temperature is relatively
low. If the warning lamp/display comes on,
adjust the tyre inflation pressure.
Whenever the tyres and wheels
are replaced with new ones
E00637400126
If new wheels with new tyre inflation pres-
sure sensors are installed, their ID codes must
be programmed into the TPMS. Have tyre
and wheel replacement performed by a
MITSUBISHI MOTORS Authorized Service
Point to avoid the risk of damaging the tyre
inflation pressure sensors. If the wheel re-
placement is not done by a MITSUBISHI
MOTORS Authorized Service Point, it is not
covered by your warranty.
CAUTION
l The use of non-genuine wheels will prevent
the proper fit of the tyre inflation pressure
sensors, resulting air leakage or damage of
the sensors.
Reset of low tyre pressure
warning threshold
E00637500143
The threshold is set based on the tyre pres-
sure which the reset function is executed by
following procedure.
1. Switch to the function setting screen.
Refer to “Multi-information display
switches” on page 5-04.
Refer to “Changing the function set-
tings” on page 5-13.
2. Press the switch or switch several
times to switch to the “TPMS SENSOR
RESET” screen.
Then, press the switch to switch to en-
ter the setting selection screen.
(reset of low tyre pressure warning
threshold)
3. Press the switch or switch to select
“RESET”, and then press and hold the
switch for approximately 3 seconds or
more to confirm the setting.
The setting is changed to the reset.
4. The warning lamp start flashing slowly.
5. Drive for a while. The reset is completed
if the warning lamp goes out.
NOTE
l The reset function should be executed every
time when the tyre pressure or tyre rotation
is adjusted.
Tyre pressure monitoring system (TPMS)*
6-108
OGKE18E1
Starting and driving
6