Mitsubishi AJ65BT-R2N, User Manual

Page: 10 / 30

2
2. SPECIFICATIONS
2.1 General Specifications
*1 Do not use or store the AJ65BT-R2N in an environment where the
atmospheric pressure is higher than the one at 0m elevation.
Doing so may cause malfunctions. For use in a compressed-air environment,
please consult your local Mitsubishi representative.
*2 It indicates the device is to be connected to which power distribution part,
within the area from the public electricity network to machinery in the
premise. Category II applies to devices to which power is supplied from fixed
installations.
The surge voltage withstand for devices rated up to 300V is 2500V.
*3 This is an index showing the degree of the conductive pollution that can
occur in the environment where the device is used.
In Pollution degree 2, only nonconductive pollution occurs. Occasionally,
however, temporary conductivity caused by condensation can be expected.
Table 2.1 General specifications
Item Specification
Operating ambient
temperature
0 to 55
Storage ambient
temperature
-20 to 75
Operating ambient
humidity
10 to 90%RH, condensation not allowed
Storage ambient
humidity
10 to 90%RH, condensation not allowed
Vibration resistance
Compliant
with JIS B
3502,
IEC 61131-2
For intermittent vibration
No. of
sweeps
Frequency Acceleration Amplitude
10 to 57Hz - 0.075mm
10 times
each in X, Y
and Z
directions
(for 80
minutes)
57 to 150Hz 9.8m/s
2
-
For continuous vibration
Frequency Acceleration Amplitude
10 to 57Hz - 0.035mm
57 to 150Hz 4.9m/s
2
-
Shock resistance
Compliant with JIS B 3502, IEC 61131-2 (147m/s
2
, 3 times each in
X, Y and Z directions)
Operating atmosphere No corrosive gases
Operating altitude
*1
2000m or lower
Installation location Inside control panel
Overvoltage category
*2
II or lower
Pollution degree
*3
2 or lower