Mitsubishi 2015 OUTLANDER, Owner'S Manual

Page: 161 / 490

Check engine warning lamp
E00502602967
This lamp is a part of an on-
board diagnostic system
which monitors the emis-
sions, engine control system
or A/T control system/CVT
control system.
If a problem is detected in one of these sys-
tems, this lamp illuminates or flashes.
Although your vehicle will usually be driva-
ble and not need towing, we recommend you
to have the system checked as soon as possi-
ble.
This lamp will also illuminate when the igni-
tion switch is turned “ON” or the operation
mode is put in ON, and goes off after the en-
gine has started. If it does not go off after the
engine has started, we recommend you to
have the vehicle checked.
CAUTION
l Prolonged driving with this lamp on may
cause further damage to the emission control
system. It could also affect fuel economy
and drivability.
l If the lamp does not illuminate when the ig-
nition switch is turned to the “ON” position
or the operation mode is put in ON, we rec-
ommend you to have the system checked.
CAUTION
l If the lamp illuminates while the engine is
running, avoid driving at high speeds and
have
the system inspected by a
MITSUBISHI MOTORS Authorized Serv-
ice Point as soon as possible.
Accelerator pedal and brake pedal response
may be negatively influenced under these
conditions.
NOTE
l
The engine electronic control module ac-
commodating the onboard diagnostic system
has various fault data (especially about the
exhaust emission) stored.
This data will be erased if a battery cable is
disconnected which will make a rapid diag-
nosis difficult. Do not disconnect a battery
cable when the check engine warning lamp is
ON.
Charge warning lamp
E00502701277
This lamp illuminates when
the ignition switch is turned
to the“ON” position or the
operation mode is put in ON,
and goes off after the engine
has started.
On vehicles equipped with the multi informa-
tion display - Type 1: A warning is also dis-
played on the multi information display.
CAUTION
l If it illuminates while the engine is running,
there is a problem in the charging system.
Immediately park your vehicle in a safe
place and we recommend you to have it
checked.
Oil pressure warning lamp
(Vehicle equipped with the
multi information display -
Type 2)
E00502800705
This lamp illuminates when
the ignition switch is turned
to the“ON” position or the
operation mode is put in ON,
and goes off after the engine
has started. If it illuminates
while the engine is running, the oil pressure
is too low.
Turn the engine off and have it inspected.
Warning lamps
5-51
OGFE16E1
Instruments and controls
5