Mitsubishi 2015 OUTLANDER SPORT/RVR, Owner'S Manual

Page: 123 / 384

4-wheel drive operation
5-60 Features and controls
5
Set the drive mode-selector to “4WD LOCK”
or “LOCK” and then gradually depress the
accelerator pedal for a smooth start. Keep the
pressure on the accelerator pedal as constant
as possible, and drive at low speed.
Your vehicle may not provide sufficient hill
climbing ability and engine braking on steep
slope. Avoid driving on steep slopes even
though the vehicle is an 4-wheel drive vehi-
cle.
N00537800098
If the electrical circuits become wet, further
operation of the vehicle will be impossible;
therefore, avoid driving through water unless
absolutely necessary. If driving through water
is unavoidable, use the following procedure:
Check the depth of the water and the terrain
before attempting to drive through it. Drive
slowly to avoid creating excessive water
splashing.
Driving on sandy or muddy
roads
CAUTION
 Do not force the vehicle or drive recklessly
on sandy surfaces. In comparison with nor-
mal road surfaces, the engine and other
drive-system components are put under
excessive strain when driving on such a sur-
face. This could lead to accidents.
 If any of the following conditions occur
while the vehicle is being driven, immedi-
ately park your vehicle in a safe place and
follow these procedures:
• If the engine coolant temperature display
flashes on the information screen in the
multi-information display or the engine
power drops suddenly.
Refer to “Engine overheating” on page 8-4.
• If the “ ” warning display and “SLOW
DOWN” or the “ ” warning display and
“SERVICE REQUIRED” appear on the
information screen in the multi-information
display.
Refer to “Warning display” on page 5-52.
WARNING
 When attempting to rock your vehicle out
of a stuck position, be sure that the area
around the vehicle is clear of people and
physical objects. The rocking motion may
cause the vehicle to suddenly launch for-
ward/backward, causing injury or dam-
age to nearby people or objects.
NOTE
 Avoid sudden braking, sudden acceleration
and sharp turning; such operations could
result in the vehicle becoming stuck.
 If the vehicle becomes stuck in sandy or
muddy roads, it can often be moved with a
rocking motion. Move the gearshift lever
alternately between the 1st and “R”
(Reverse) positions (M/T), the “D” (DRIVE)
and “R” (REVERSE) positions (CVT), while
pressing lightly on the accelerator pedal.
 Driving on rough road can cause rust on the
vehicle; wash the vehicle thoroughly as soon
as possible after such use.
Climbing/descending sharp
grades
Driving through water
CAUTION

Never drive through water that is deep
enough to cover wheel hubs, axles or exhaust
pipe. Do not change the gearshift lever posi-
tion (M/T) or the selector lever position
(CVT) while driving through water.
Frequent driving through water can
adversely affect the life span of the vehicle;
consult an authorized Mitsubishi Motors
dealer or a repair facility of your choice and
take the necessary measures to prepare,
inspect, and repair the vehicle.
BK0206700US.book 60 ページ ２０１４年３月２５日 火曜日 午後４時４２分