Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 721 / 1164

ABS <4WD> -
G Sensor
35C-7
G SENSOR
35201010177
REMOVAL AND INSTALLATION
Caution
Do not drop the G sensor or subject it to any shocks.
1
2
Removal steps
1. Parking cover
2. G sensor
INSPECTION
35201020156
1. Remove the G sensor.
2. Connect the special tool between the disconnected
connectors, and then place the G sensor horizontally
as shown in the illustration.
3. Turn on the ignition switch, and then measure the voltage
between terminal No.2 and body earth.
Standard value: 2.4 - 2.6 V
4. Face the labeled surface straight down with the special
tool still connected. Measure the voltage between terminal
No.2 and body earth with the labeled surface faced straight
down.
Standard value: 3.3 - 3.7 V
5. If not within the standard value, check the power supply
line and earth condition, and then replace the G sensor.
MB991348
Label
Labeled surface