Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 306 / 548

l The system has been placed in the ‘ON
state’.
NOTE
l The system stays in the “ON” state for ap-
proximately 7 seconds after the hazard lamp
has stopped flashing or the turn-signal lever
has returned to the home position.
Lane departure warning
A buzzer sounds intermittently and indication
of “LANE DEPARTURE” appears in the in-
formation display,
indicator flashing in
amber when your vehicle is about to leave or
has left the lane in the standby mode.
NOTE
l If the warning continues for approximately 3
seconds or more, the system switches to the
standby mode before the warning stops.
l If the lane markers are only on one side of
the road, the LDW will operate only for the
appropriate side where the lane marker is
drawn.
System problem warning
E00635901049
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
Too hot or cold sensor
E00638700054
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to a too high or low temperature of the sen-
sor.
If the temperature of the sensor reaches the
predetermined value, the system automatical-
ly recovers the normal state.
If the alarm continues showing, there is a
possibility that the LDW has a malfunction.
Contact a MITSUBISHI MOTORS Author-
ized Service Point for inspection of the sys-
tem.
Windscreen is dirty
E00652600028
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to dirt on the windscreen at the sensor por-
tion.
After having cleaned the windscreen, the sys-
tem will automatically return to operation.
If the alarm continues showing, there is a
possibility that the sensor has a malfunction.
Contact a MITSUBISHI MOTORS Author-
ized Service Point for inspection of the sen-
sor.
Lane Departure Warning (LDW)*
7-87
OGGE17E1
Starting and driving
7