Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 288 / 548

NOTE
l A sound will be heard during the activation
of automatic braking, this is a function of the
brake control and is not abnormal.
FCM and Ultrasonic misaccel-
eration Mitigation System
ON/OFF switch
E00635601264
This switch is used to turn on and off the
FCM and Ultrasonic misaccelration Mitiga-
tion System and also to select your desired
collision alarm timing.
When the switch is held pressed, the
ON/OFF state of the FCM and Ultrasonic
misaccelration Mitigation System changes
from ON to OFF and vice versa. If you give
the switch a short press with the FCM in the
ON state, you can change the collision alarm
timing.
NOTE
l When the FCM and Ultrasonic misaccelera-
tion Mitigation System ON/OFF switch is
held pressed to change the ON/OFF state of
the FCM, the ON/OFF state of the Ultrason-
ic misacceleration Mitigation System is also
changed at the same time.
To turn on/off the system
You can switch the system from OFF to ON
or ON to OFF if you hold the FCM and Ul-
trasonic misacceleration Mitigation System
ON/OFF switch pressed when the operation
mode is set to “ON”.
Once the system is turned on, the information
screen of the multi-information display
shows the collision alarm timing currently se-
lected, and the
indicator on the screen
goes out.
When you turn off the system, the following
message appears on the screen and the
in-
dicator comes on.
Cycling the operation mode to ON will set
the FCM back ON.
NOTE
l
The indicator is combined with the “Ul-
trasonic misacceleration Mitigation System
OFF” indicator.
To change alarm timing
Give a short press to the FCM and Ultrasonic
misacceleration Mitigation System ON/OFF
switch to change the timing at which the
frontal collision alarm is triggered. Every
time you press the switch, the alarm timing
changes between three levels: “FAR” (earlier
alarming), “MIDDLE” (normally alarming)
or “NEAR” (later alarming).
Forward Collision Mitigation System (FCM)*
7-69
OGGE17E1
Starting and driving
7