Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 235 / 548

Remove the keyless operation key from the
key slot after starting the Plug-in Hybrid EV
System or changing the operation mode.
NOTE
l Do not insert into the key slot anything other
than the keyless operation key. This could
cause damage or a malfunction.
l Remove the object or additional key from
the the keyless operation key before insert-
ing the key into the key slot. The vehicle
may not be able to receive the registered ID
code from the registered key. Therefore, the
Plug-in Hybrid EV System may not start and
the operation mode may not change.
l The keyless operation key is fixed in the key
slot when inserted in the illustrated direc-
tion. Simply pull out the key to remove it
from the key slot.
Keyless operation key remind-
er
E00633001046
If the operation mode is in OFF and the driv-
er’s door is opened with the keyless operation
key in the key slot, the outer buzzer sounds
for approximately 3 seconds and the inner
buzzer sounds for approximately 1 minute or
a warning display will appear to remind you
to remove the key.
Selector lever (Joystick
type)
E00636100096
Selector lever operation
E00636200097
The selector lever always returns to its home
( ● ) position when it is released.
The position you select with the selector lev-
er will be illuminated on the shift position
panel shown in the illustration below.
Home
position
Move the selector lever slowly and securely
in the following method.
l To select “D” (DRIVE) or “R” (RE-
VERSE):
Move the selector lever in the direction
of the arrow.
l To select “N” (NEUTRAL):
Move the selector lever in the direction
of the arrow and hold it for a while.
l To select “B” (REGENERATIVE
BRAKE):
Move the selector lever in the direction
of the arrow.
Selector lever (Joystick type)
7-16
OGGE17E1
Starting and driving
7