Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 233 / 548

NOTE
l It is possible to modify functions as follows:
• The time until the power cuts out can be
changed to approximately 60 minutes.
• The ACC power auto-cutout function can
be deactivated.
For details, we recommend you to consult
a MITSUBISHI MOTORS Authorized
Service Point.
On vehicles equipped with the Smart-
phone Link Display Audio or the
MITSUBISHI Multi-Communication Sys-
tem (MMCS), screen operations can be
used to make the adjustment.
Refer to the separate owner’s manual for
details.
Operation mode OFF reminder
system
E00632201041
When the operation mode is in any mode oth-
er than OFF; if you close all the doors and
the tailgate, and then try to lock the doors and
tailgate by pressing the driver’s or front pas-
senger’s door lock/unlock switch, or the tail-
gate LOCK switch, a warning lamp will blink
or warning display will appear, and the outer
buzzer will sound preventing you from lock-
ing the doors and tailgate.
Operation mode ON reminder
system
E00632301068
If the driver’s door is opened while the Plug-
in Hybrid EV System is stopped and the op-
eration mode in any mode other than OFF,
the operation mode ON reminder inner buz-
zer sounds intermittently to remind you to put
the operation mode in OFF.
Starting and stopping the
Plug-in Hybrid EV System
E00620601295
Starting the Plug-in Hybrid EV
System
E00620701661
CAUTION
l When the Plug-in Hybrid EV System warn-
ing lamp comes on while the READY indi-
cator is on, avoid high-speed driving and
have your vehicle inspected by a
MITSUBISHI MOTORS Authorized Serv-
ice Point as soon as possible. (Refer to
“Plug-in Hybrid EV System warning lamp”
on page 6-52.)
l Never attempt to start the engine by pushing
or pulling the vehicle.
1. Check that the EV charging cable is not
connected to your vehicle.
2. Fasten the seat belt.
3. Make sure the parking brake is applied.
4. Press and hold the brake pedal down
firmly with your right foot.
5. When you press the power switch while
depressing the brake pedal, the READY
indicator in the meter blinks and the acti-
vation of Plug-in Hybrid EV System
starts.
Starting and stopping the Plug-in Hybrid EV System
7-14
OGGE17E1
Starting and driving
7