Mitsubishi MOTORS Outlander PHEV 2016, Owner'S Manual, Page: 437 / 490

NOTE
l If you are unsure of how to carry out the
work as required, we recommend you to
consult a specialist.
l Be careful not to scratch the vehicle body
when removing a lamp or lens.
l When it rains or when the vehicle has been
washed, the inside of the lens sometimes be-
comes foggy. This is the same phenomenon
as when window glass mists up on a humid
day, and does not indicate a functional prob-
lem.
When the lamp is switched on, the heat will
remove the fog. However, if water gathers
inside the lamp, we recommend you to have
the lamp checked.
Bulb location and capacity
E01003200333
When replacing a bulb, use a new bulb with
the same wattage and colour.
Outside
E01003304677
Front
Type A
Type B
Type A: Halogen headlamps type
Type B: LED headlamps type
1- Front turn-signal lamps: 21 W (PY21W)
2- Headlamps, high-beam: 60 W (HB3)
3- Headlamps, low beam
Halogen: 55 W (H7)
LED: −
4- Position lamps: −
Daytime running lamps: −
5- Front fog lamps: 19 W (H16)
6- Side turn-signal lamps: −
Codes in parentheses indicate bulb types.
NOTE
l The following lamps use an LED instead of
the bulb. If you need to repair or replace
these lamps, contact a MITSUBISHI
MOTORS Authorized Service Point.
• Headlamps, low beam (LED type)
• Position lamps
• Daytime running lamps
•
Side turn-signal lamps
1- High-mounted stop lamp: −
2- Tail lamps: −
Replacement of lamp bulbs
11-23
OGGE16E1
Maintenance
11