Mitsubishi MOTORS Outlander PHEV 2016, Owner'S Manual, Page: 401 / 490

Refer to “Tyre pressure monitoring sys-
tem (TPMS): Reset of low tyre pressure
warning threshold” on page 7-75.
CAUTION
l After changing the tyre and driving the vehi-
cle about 1,000 km (620 miles), retighten the
wheel nuts to make sure that they have not
come loose.
l If the steering wheel vibrates when driving
after changing the tyre, we recommend you
to have the tyres checked for balance.
l Do not mix one type of tyre with another or
use a different size from the one listed. This
would cause early wear and poor handling.
To store the tools and jack
E00803800037
Reverse the removing procedure when stor-
ing the jack, jack bar and wheel nut wrench.
Refer to “Tools and jack” on page 9-06.
Wheel covers*
E00801300735
To remove
Wrap the tip of the jack bar with a cloth, in-
sert it into the notch provided in the wheel
cover, and pry the cover away from the
wheel. Using the same procedure at the other
wheel cover notches, work the wheel cover
away from the wheel to remove it complete-
ly.
CAUTION
l Removing the cover with your hands may
cause injury to the fingers.
NOTE
l The wheel cover is made of plastic. Pry it
loose carefully.
To install
1. Make sure the tabs (A) of the back of the
wheel cover are not broken and correctly
fitted on the rings (B). If in doubt, do not
install the wheel cover and consult your
MITSUBISHI MOTORS Authorized
Service Point.
2. Align the air valve (C) of the tyre with
the notch (D) in the wheel cover.
How to change a tyre
9-17
OGGE16E1
For emergencies
9