Mitsubishi MOTORS Outlander PHEV 2016, Owner'S Manual, Page: 150 / 490

EV cruising range display/
Total cruising range display
E00537600026
This displays the approximate driving range
(how many more kilometres or miles you can
drive).
EV cruising range display (A)
This displays the distance that can be traveled
with the remaining power in the drive bat-
tery.
Total cruising range display (B)
This displays the distance that can be traveled
with the remaining power in the drive battery
and the remaining amount of fuel.
NOTE
l The driving range may vary depending on
the driving conditions and habits. Treat the
distance displayed as just a rough guideline.
NOTE
l When the drive battery is charged or the ve-
hicle is refueled, the cruising range display
is updated. However, if the charge level is
low or the refueling amount is small, it can-
not be updated correctly. Fully charge the
battery or refill to full tank whenever possi-
ble.
l On rare occasions, the value displayed for
the driving range may change if you are
parked on an extremely steep incline. This is
due to the movement of fuel in the tank and
does not indicate a malfunction.
l The display setting can be changed to the
preferred units (km or miles).
Refer to “Changing the function settings” on
page 6-16.
l When the EV cruising range falls below ap-
proximately 1 km (1 mile), the EV cruising
range display shows “---”.
l When the total cruising range falls below ap-
proximately 50 km (30 miles), the total
cruising range display shows “---”.
Average fuel consumption dis-
play
E00531201128
This displays the average fuel consumption
from the last reset to the present time.
There are the following 2 mode settings.
Refer to “Changing the reset mode for aver-
age fuel consumption” on page 6-17.
For information on how to change the aver-
age fuel consumption display setting, refer to
“Changing the function settings” on page
6-16.
NOTE
l The average fuel consumption display can
be reset separately for the auto reset mode
and for the manual reset mode.
l
“---” is displayed when the average fuel con-
sumption cannot be measured.
l The initial (default) setting is “Auto reset
mode”.
l
The average fuel consumption depends on
the driving condition (road condition, driv-
ing behavior, etc.). The displayed fuel con-
sumption may vary from the actual fuel con-
sumption. Treat the fuel consumption dis-
played as just a rough guideline.
l The memory of the auto reset mode or man-
ual reset mode for the average fuel con-
sumption display is erased if the auxiliary
battery is disconnected.
l The display setting can be changed to the
preferred units {km/L, mpg (US), mpg (UK)
or L/100 km}.
Refer to “Changing the function settings” on
page 6-16.
Multi information display
6-14
OGGE16E1
Instruments and controls
6