Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 77 / 250

NOTE
l
The distance is shown in units of 100 km
(100 miles). The time is shown in units of
months.
2. This informs you that a periodic inspection is
due. Consult a MITSUBISHI MOTORS Au-
thorized Service Point.
3. After your vehicle is inspected at a
MITSUBISHI MOTORS Authorized Service
Point, it displays the time until the next peri-
odic inspection.
To reset
The “---” display can be reset while the ignition
switch or the operation mode is in OFF.
1. When you lightly press the multi-informa-
tion display switch a few times, the informa-
tion display switches to the service reminder
display.
2. Press and hold the multi-information display
switch for about 1 second or more to make
the spanner mark start flashing. (If there is
no operation for about 10 seconds with flash-
ing, the display will revert to its original indi-
cation.)
3. Lightly press the multi-information display
switch while the icon is flashing to change
the display from “---” to “cLEAr”. After this,
the time until the next periodic inspection
will be displayed.
CAUTION
l
The customer is responsible for making
sure that periodic inspection and mainte-
nance are performed. Inspections and
maintenance must be performed to pre-
vent accidents and malfunctions.
NOTE
l “---”display cannot be reset when the igni-
tion switch or the operation mode is in ON.
l When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l If you accidentally reset the display, consult
a MITSUBISHI MOTORS Authorized Serv-
ice Point.
Changing the function settings
E00522700726
The average fuel consumption reset mode, fuel con-
sumption unit and temperature unit setting can be
modified as desired, when the ignition switch or
the operation mode is ON.
CAUTION
l The driver should not operate the display
while the vehicle is in motion.
l When operating the system, stop the vehi-
cle in a safe area.
Changing the reset mode for average fuel con-
sumption
E00522901044
The mode conditions for the average fuel consump-
tion display can be switched between “Auto reset”
and “Manual reset”.
1. When you lightly press the multi-informa-
tion display switch a few times, the informa-
tion display switches to the driving range dis-
play.
Refer to “Information display” on page 3-03.
Instruments and controls
3-07
OA0X13E4
3