Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 47 / 250

Heated seats*
E00401101130
The heated seats can be operated with the ignition
switch or the operation mode is in ON. Operate the
switch as indicated by arrows. The indication lamp
(A) will illuminate while the heater is on.
1 (HI) - Heater high (for quick heating).
2 - Heater off.
3 (LO) - Heater low (to keep the seat warm).
CAUTION
l Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater
to low to keep it warm. Slight variations
in seat temperature may be felt while us-
ing the heated seats. This is caused by the
operation of the heater’s internal thermo-
stat and does not indicate a malfunction.
l
If the following types of persons use the
heated seats, they might become too hot
CAUTION
or receive minor burns (red skin, heat blis-
ters, etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcohol
or sleep inducing medication (cold
medicine, etc.)
l Do not place heavy objects on the seat or
stick pins, needles, or other pointed ob-
jects into it.
l Do not use a blanket, cushion, or other ma-
terial with high heat insulation properties
on the seat while using the heater; this
might cause the heater element to overheat
l Do not use benzine, kerosene, petrol, alco-
hol or other organic solvents when clean-
ing the seats. Doing so could damage not
only the seat cover, but also the heater el-
ement.
l If water or any other liquid is spilled on
the seat, allow it to dry thoroughly before
attempting to use the heater.
l Turn the heater off immediately if it ap-
pears to be malfunctioning during use.
Rear seat
E00401300018
Folding the seatbacks forward
E00401600428
The passenger and luggage compartments can be
joined by folding the rear seatback forward. This is
useful for carrying long objects.
To fold
1. If your vehicle is equipped with head re-
straints, place each head restraint in its low-
est position. (Refer to “Head restraints” on
page 2-04.)
2. Pull the left or right release bands (A), and
fold the rear seatbacks forward.
3. Store the seat belt plate of the outboard seat-
ing position. (Refer to “Rear seat belt stor-
age” on page 2-07.)
To return
1. Confirm that the seat belt plate of the out-
board seating position is stored.
Seat and seat belts
2-03
OA0X13E4
2