Mitsubishi MOTORS LANCER EVOLUTION, Owner'S Manual

Page: 43 / 330

9. Turn the emergency key with the keyless op-
eration key to the “START” position without
depressing the accelerator pedal, and release
it when the engine starts.
10. Remove the keyless operation key from the
emergency key.
WARNING
l
Make sure to remove the keyless opera-
tion key from the emergency key after
the engine is started.
If not removed, the keyless operation key
could fall to the floor, which could dis-
turb the pedal operation. Furthermore,
the keyless operation key could prevent
the driver’s knee airbag from inflating
normally or could be propelled to cause
serious injury if the airbag inflates.
NOTE
l
If the emergency key is attached to a key
holder, it may become impossible to insert
the keyless operation key into the emergency
key, and it may prevent the engine from be-
ing started. When using the emergency key
to start the engine, first remove the key from
the key ring.
When it is difficult to start the engine
After several attempts, you may experience that the
engine still does not start.
1. Make sure that all electric devices, such as
lamps, air con-ditioning blower and rear win-
dow demister, are turned off.
2. While depressing the brake pedal, press the
accelerator pedal halfway and hold it there,
then crank the engine. Release the accelera-
tor pedal, immediately after the engine starts.
3. If the engine still will not start, the engine
could be flooded with too much petrol.
While depressing the brake pedal, push the
accelerator pedal all the way down and hold
it there, then crank the engine for 5 to 6 sec-
onds. Return the ignition switch to the
“LOCK” position and release the accelerator
pedal. Wait a few seconds, and then crank
the engine again for 5 to 6 seconds while de-
pressing the brake pedal, but do not push the
accelerator pedal. Release the ignition key if
the engine starts. If the engine fails to start,
repeat these procedures. If the engine still
will not start, we recommend you to have the
vehicle checked.
Keyless entry system
E00307701010
Press the remote control switch to lock or unlock
the doors and to open the trunk lid.
It is also possible to operate the outside rear-view
mirrors.
(Vehicles equipped with the mirror retractor
switch)
1- LOCK ( ) switch
2- UNLOCK ( ) switch
3- Electric trunk lid (
) switch
4- Indication lamp
To lock
Press the LOCK switch (1). All the doors will be
locked. The turn-signal lamps will blink once.
NOTE
l
With a vehicle that has a Dead Lock System,
pressing the LOCK switch (1) two times in
succession causes the Dead Lock System to
be set. (Refer to “Setting the system” on
page 1-24.)
To unlock
Press the UNLOCK switch (2). All the doors will
be unlocked. If the front room lamp switch is in the
“DOOR” position or the rear room lamp switch is
in the middle (•) position, the room lamp will come
on for approximately 15 seconds and the turn-sig-
nal lamps will blink twice.
Locking and unlocking
1-19
OCZE14E3
1