Mitsubishi MOTORS Eclipse Cross 2019, Owner'S Manual, Page: 64 / 602

To deactivate the vehicle impact
detection function and the inte-
rior intrusion detection function
The vehicle impact detection function and the
interior intrusion detection function can be
deactivated when parking in automated car
parks, leaving pets in the vehicle or leaving
the vehicle with the windows slightly open.
1. Turn the ignition switch to the “LOCK”
position and then remove the key (ex-
cept for vehicles equipped with the key-
less operation system), or put the opera-
tion mode in OFF (vehicles equipped
with the keyless operation system).
2. Raise and hold the wiper and washer
switch to the “MIST” position for ap-
proximately 3 seconds. The buzzer will
sound twice and the function will be de-
activated.
To activate the function again, raise and hold
the wiper and washer switch to the “MIST”
position for approximately 3 seconds.
The buzzer will sound once and the function
will be activated.
NOTE
l The function will be activated again if the
following operation is performed.
• If the doors and the tailgate are unlocked
using the keyless entry system or the key-
less operation function.
• If the ignition switch is turned to the
“ON” or “ACC” position or the operation
mode is put in ON or ACC.
Cancelling the system
The following methods can be used to cancel
the system when it is in the system prepara-
tion mode or the system armed mode.
l Pressing the UNLOCK switch on the
key.
l Turning the ignition switch to the “ON”
position. (except for vehicles equipped
with the keyless operation system)
l Putting the operation mode in ON. (vehi-
cles equipped with the keyless operation
system)
l Opening any one of the doors or the tail-
gate, or inserting the key into the igni-
tion switch (except for vehicles equipped
with the keyless operation system) when
the system is in the system preparation
mode.
l Holding the keyless operation key and
pressing the driver’s or front passenger’s
door lock/unlock switch, or the tailgate
open switch to unlock the doors and the
tailgate (vehicles equipped with the key-
less operation system).
NOTE
l If the bonnet is opened during the system
preparation mode, the system preparation
mode is suspended.
The system returns to the system preparation
mode when the bonnet is closed.
l If the battery terminals are disconnected
while the system is in the system preparation
mode, the memory will be erased.
Security alarm system*
3-28
OGKE20E1
Locking and unlocking
3