Mitsubishi MOTORS Eclipse Cross 2018, Owner'S Manual, Page: 257 / 538

If the display keeps showing the message,
there is a possibility that the FCM has a mal-
function. Contact a MITSUBISHI MOTORS
Authorized Service Point for inspection of
the system.
FCM deactivation due to fault
If the FCM detects a malfunction in the sys-
tem, either one of the following messages
will appear on the information screen of the
multi-information display, the
indicator
will come on in the instrument cluster and the
FCM will automatically be turned off.
If the message remains even after the ignition
switch is turned to the “LOCK” position and
then turned back to the “ON” position or the
operation mode is put in OFF, and then
turned back to “ON”, please contact a
MITSUBISHI MOTORS Authorized Service
Point.
If the display keeps showing the message,
there is a possibility that the FCM has a mal-
function.
Contact a MITSUBISHI MOTORS Author-
ized Service Point.
NOTE
l
If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “FCM
SERVICE REQUIRED” message may ap-
pear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the en-
gine, please contact a MITSUBISHI
MOTORS Authorized Service Point.
Handling of the sensor
The sensor (A) is located inside the wind-
screen and front bumper (Type 2 only) as
shown in the illustration.
The sensor is shared in the following sys-
tems:
l Forward Collision Mitigation system
(FCM)
l Lane Departure Warning (LDW)
l Automatic High-Beam (AHB)
l Adaptive Cruise Control System
(ACC)*
Type 1
Type 2
Forward Collision Mitigation System (FCM)
6-87
OGKE18E5
Starting and driving
6