20
VS-60HS12U Set-up Manual
In
itia
l s
ett
in
g
MASTER
slave
slave
slave
ON
OFF
1 2 3 4
Internal cabling
Run cables through the cable covers located on both
sides and top/bottom of the cabinets.
Punch a hole in the center slit of the covers at
necessary points for the cabling.
•
To block dust, do not break the covers which are not
used for cabling.
•
For the safety reason, do not leave a power strip
inside the cabinet.
For vertical cabling:
Lace the supplied plastic ties through the holes in 1
unit of mount bases on the right side of the cabinet’s
inner surface, and fasten the cables with this tie.
For horizontal cabling:
Lace the plastic ties through the holes in 5 units of
mount bases on the inner surface of the skirt part
underneath the screen area and fasten the cables with
them.
3.1.2
Dipswitch setting
Adequately set the dipswitches on the control panel
according to system configurations.
•
Change the switches while the power is off. Turning
on the main power switch renews the setting.
•
Normally, there is no need to change the switches #1
and 2.
No. Name
Function
Default
1 ON - RESERVED For factory setting
ON
2 ON - RESERVED For factory setting
ON
3 REMOTE
For wireless remote control
(ON: accept, OFF: reject)
ON
4 MASTER/SLAVE Mater / slave setting
(ON: MASTER, OFF: slave)
OFF
MASTER / slave setting
n
Switch #4 (ON: MASTER, OFF: slave)
Surely set a monitor as MASTER in a display wall and
others as slave monitors.
The MASTER monitor directs toward / collects
information from slave monitors.
Wireless remote control invalidation
n
Set the switch #3 when needed.
It can reject wireless remote control, i.e. to avoid
controlling other monitors unintentionally.
Mount
base
Mount
base
Cover
Cover
