Mitsubishi Electric RD81DL96, User Manual

Page: 51 / 124

4 PROCEDURES PRIOR TO OPERATION
4.1 Start up of High Speed Data Logger Module
49
4
4
PROCEDURES PRIOR TO OPERATION
This chapter shows the procedure prior to the operation of the high speed data logger module.
4.1
Start up of High Speed Data Logger Module
Procedure to operate by installing the configuration tool
This section shows the procedure for using the high speed data logger module by installing the configuration tool.
For the setting method using the configuration tool, refer to the following manual.

MELSEC iQ-R High Speed Data Logger Module User's Manual(Application)
*1 Perform a self-diagnostics test as necessary. (

MELSEC iQ-R High Speed Data Logger Module User's Manual(Application))
*2 Do not use an electric screwdriver to attach and remove module fixing screws.
*3

Page 77 INSTALLATION AND UNINSTALLATION
*4  Page 68 System configuration for the initial setup, maintenance, and inspection
*5

Page 62 SD Memory Card
*6  Page 52 Offline startup
High speed data logger module *1 Configuration personal computer
Mount to base *2 Install the Configuration Tool
*3
Connect the high speed data logger module and configuration personal computer on a 1:1 basis.
*4
Turn ON the system
(RUN LED turns ON)
Insert the SD memory card. *5
Start the Configuration Tool
*6
Select "Direct connection"
from the "Transfer setup" screen
Format the SD Memory card.
Configure common settings.
Set the Data logging setting, Event logging setting,
and Report setting
Write the settings to the high speed data logger module.
Connect the configuration personal computer and the high speed data logger module
according to the "Network Setting"
Start operation