318
10.12
JP/GP.REQ (Reading/Writing Clock Data)
This instruction reads and writes the clock data of the programmable controller on another station.
*1
Local devices and file registers set for each program cannot be used.
(1) Setting data
Setting
data
*1
Available devices
Internal device
(System, user)
File
register
R, ZR
Link direct device
J
\
Intelligent
function module
device
U
\
G
Index register
Zn
Constant
Others
Bit
Word
Bit
Word
K, H
$
(S1)
(S2)
(D1)
(D2)
Setting data
Description
Set by
Data type
Jn
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
User
16-bit binary
Un
Start I/O number of the master/local module of own station
(00 to FE
H
: Upper two digits of the I/O number expressed in three
digits)
(S1)
Start device of the own station where control data is stored
Device name
(S2)
Start device of the own station where receive data is stored
(D1)
Start device of the own station where response data is stored
System
(D2)
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D2)+1 also turns on.
Bit
JP.REQ
Start contact
GP.REQ
Start contact
JP.REQ
Jn
GP.REQ
Un
(S1)
(D1)
(D2)
(S2)
(S1)
(D1)
(D2)
(S2)
