Mitsubishi Electric PUHY-P1000, Service Handbook

Page: 277 / 334

[8-9 Troubleshooting Inverter Problems ]
- 268 -
HWE14040 GB
<INV30YC> 3) A BUS circuit error occurs immediately
after compressor startup.
Error code : 4220
Detail code : 124 a. Check that 12 VDC is supplied to
the relay at startup (Check that
LED5 lights up.)Between pins 1 (+)
and 2 (-) on the CNRY connector
b. Replace the inverter board if no
problems were found with item a.
4) An overcurrent error occurs during oper-
ation.
Error code : 4250
Detail code : 121,122 [8-9-6 Checking the Converter for
Damage during Compressor Oper-
ation](page 269)
5) An overcurrent error occurs immediately
after compressor startup.
Error code : 4250
Detail code :101,106,107,128 a. Check for refrigerant flooding.
→
When the problem persists after
compressor startup was repeated
several times, go to "d" after a cer-
tain time after energizing the com-
pressor or the heater.
If normal operation is restored,
check the belt heater for problems.
b. Check that there is a pressure dif-
ference between high and low
pressures after compressor start-
up.
→
Check the high pressure with
LED monitor for changes.
Replace the compressor if there is
no pressure difference. (the com-
pressor may be locked.)
c. Check for interphase voltage im-
balance.
d. Replace the INV board if no prob-
lems were found with the items a or
c.
e. If the problem persists after replac-
ing the inverter board,[8-9-3
Checking the Compressor for
Ground Fault and Coil Resistance
Problems](page 266)
6) An overvoltage error occurs during oper-
ation.
Error code : 4220
Detail code :109,110,112 [8-9-6 Checking the Converter for
Damage during Compressor Oper-
ation](page 269)
7) No problems were found with items 1)
through 6). Normal[8-9-6 Checking the Con-
verter for Damage during Com-
pressor Operation](page 269)
Items to be checked Phenomena Remedy